dallo studio di James Millette


Conclusions

The red/gray chips found in the WTC dust at four sites in New York City are consistent
with a carbon steel coated with an epoxy resin that contains primarily iron oxide and
kaolin clay pigments.

There is no evidence of individual elemental aluminum particles of any size in the
red/gray chips, therefore the red layer of the red/gray chips is not thermite or nanothermite. ( lo studio di Harrit e co dimostra il contrario, chi ha ragione? )


Notes on the Source of the Red/Gray Chips

At the time of this progress report, the identity of the product from which the red/gray
chips were generated has not been determined. The composition of the red/gray chips
found in this study (epoxy resin with iron oxide and kaolin pigments) does not match the
formula for the primer paint used on iron column members in the World Trade Center
towers (Table 1).16 Although both the red/gray chips and the primer paint contain iron oxide pigment particles, the primer is an alkyd-based resin with zinc yellow (zinc chromate) and diatomaceous silica along with some other proprietary (Tnemec )
pigments. No diatoms were found during the analysis of the red/gray chips. Some
small EDS peaks of zinc and chromium were detected in some samples but the amount
detected was inconsistent with the 20% level of zinc chromate in the primer formula.

Material Safety Data Sheets (MSDS) contain some information about product materials.
According to the MSDS currently listed on the Tnemec website,17 55 out of the 177 different Tnemec coating products contain one or two of the three major components in the red layer: epoxy resin, iron oxide and/or kaolin (aluminum silicate) pigments. However, none of the 177 different coatings are a match for the red layer coating found in this study.

ok per Millette i chip rossi non sono residui della vernice protettiva delle colonne del wtc ma non sono neanche residui di nanothermite

ma allora come si spiega la formazione delle sferette ferrose?

quindi secondo Millette se realizzo una venice a base di ossido di ferro e kaolino ( argilla bianca ) la spalmo su una sottile lastra di acciaio, la lascio asciugare e poi l'accendo questa dovrebbe fondere l'acciaio e generare delle microsfere ferose? ma in base a quale reazione chimica ?